| ||||||
Buy Rockford Fosgate x6 Amplifier
Rockford Fosgate x6 Amplifier Features
- Per channel power 425 W X 1 @ 4 Ohms RMS
- 850 W X 1 @ 2 Ohms RMS
- Total power 850 Watts Peak/Max
- Variable Crossover – The amplifiers have a built-in 24dB/octave Butterworth filter with a crossover point variable from 40Hz to 250Hz. The crossover is set to Low-Pass (LP).
- Protect LED – The (red) LED illuminates when the unit is latched
into protection. It requires momentary AP removal to enable output PWM.
- Gain Control – The input gain control is preset to match the
output of most source units. It can be adjusted to match output levels
from a variety of source units.
- Phase – Used when connecting two bd amplifiers together to phase
one amplifier 180° from the other.
- Infrasonic Filter – A high pass filter designed to prevent frequencies
below the audio range from being applied to the subwoofer from the amplifier.
Consequently, improving subwoofer performance & power handling.
- LED Power Indicator – The LED illuminates when the unit is turned
on.
- Cast Aluminum Heatsink – The cast aluminum heatsink of the amplifier
dissipates heat generated by the amplifier's circuitry. The inherent
advantage of casting provides a 30% improvement of cooling over conventional
extrusion heatsink designs.
- Sync – These amplifiers have a 6 pin mini DIN connector. When
operating two amplifiers in the bridge mode, the SYNC cable must be
used. This will allow the two independent frequency carrier generators
in each unit to be synchronized.
- Speaker Terminals – The heavy duty, gold-plated terminal block
connectors (+ & –) will accept wire sizes from 8 AWG to 18
AWG. These gold-plated connectors are immune to corrosion that can cause
signal deterioration.
- Power Terminals – The power & ground connectors on the amplifier
are gold-plated & will accommodate up to 4 AWG wire maximizing the
input current capability of the amplifier.
- REM Terminal – This terminal is used to remotely turn-on &
turn-off the amplifier when +12V DC is applied.
- RCA Input Jacks – The industry standard RCA jacks provide an
easy connection for signal level input. They are gold-plated to resist
the signal degradation caused by corrosion.
- RCA Pass-Thru Jacks – The Pass-Thru provides a convenient source
for daisy-chaining an additional amplifier without running an extra
set of RCA cables from the front of the vehicle to the rear amplifier
location.
- Punch Bass – The Punch Bass control helps correct for acoustical deficiencies in the listening environment by helping produce full range sound without adding excessive boost.. The Punch Bass control is a narrow band adjustment at 45Hz variable from 0dB to + 18dB. Connection is made with a cable using RJ-45 & can be installed under the dash for remote control access.
Click here to bookmark this page
Do you have a question? Click here to ask at deCAF: Car Audio Forum!